this is only when giving her a bit ie 70-80 on uneven surfaces
years ago had same problem on sierra that was some bushes on ends of anti roll bar
could this be the same?
any one any ideas?
530d when brake steering judder??????
Moderator: Moderators
3 posts
• Page 1 of 1
530d when brake steering judder??????
by stubbsie » Fri, 05 Aug 2005 17:11:15 UTC
-
stubbsie
- Posts: 360
- Joined: Wed, 18 May 2005 22:24:30 UTC
by jon-willy » Sat, 06 Aug 2005 19:19:43 UTC
Hi Stubbsie
Also check for any marking on your discs .... sometimes happens if you have washed the car and not taken the car for a run for a few days ..... water trapped between the disc pads and the disc cause a rust mark that ends up as a slight high spot.
Jon.
Also check for any marking on your discs .... sometimes happens if you have washed the car and not taken the car for a run for a few days ..... water trapped between the disc pads and the disc cause a rust mark that ends up as a slight high spot.
Jon.
-
jon-willy
- Posts: 1148
- Joined: Sat, 30 Apr 2005 22:06:59 UTC
- Location: South Yorkshire
by Golfather » Sat, 06 Aug 2005 20:55:27 UTC
Get the caliper checked.
I had the same problem and it was found to be a sticky piston.
It was subsequently cleaned, lubed and re-fitted and it's now on form again.
I had the same problem and it was found to be a sticky piston.
It was subsequently cleaned, lubed and re-fitted and it's now on form again.
"The Lord of the Rings"
2004 Ebony Black RS6 Avant | Milltek Non-res | Alpine 7" Multimedia/PC/DVD | MRC Stage 1+
2003 Avus Silver RS6 Saloon | Milltek Non-Res | RNS-E | MRC Stage 1+
XC90 D5 SE Geartronic
2004 Ebony Black RS6 Avant | Milltek Non-res | Alpine 7" Multimedia/PC/DVD | MRC Stage 1+
2003 Avus Silver RS6 Saloon | Milltek Non-Res | RNS-E | MRC Stage 1+
XC90 D5 SE Geartronic
-
Golfather
-
- Posts: 1798
- Joined: Sun, 29 May 2005 22:25:31 UTC
- Location: UK
3 posts
• Page 1 of 1
BMWLand: Who is online
Users browsing this BMW forum: El Burro, royleejoel, StuyMac and 37 guests